Table of Contents
Advertisement
2.5 The CertiFiber Remote
The CertiFiber Remote is an active and
intelligent far-end device that works with the
CertiFiber main unit to verify optical-cable
transmission quality. All information is
processed and transferred to the main unit.
Both units provide a consistent, calibrated light
source that increases the ease and effectiveness
of fiberoptic testing.
2.5.1 T
LED
HE
The CertiFiber Remote has four LED
indicators:
LED Name
RX1 PASS/FAIL
TX2 PASS/FAIL
850nm*
1300nm*
* Press and hold the Battery button.
The LEDs also show the results of a battery test
(which you run by pressing the Battery
button):
RX1 and TX2 LEDs
TX2 LED
RX1 LED
RX1 and TX2 LEDs
RX1 and TX2 LEDs*
*Switch fiber connectors: RX2 to TX1, TX1 to RX2, RX1 to
TX2, TX2 to RX1.
S
Color
red
green
red
green
green
green
red
red
green
green
yellow
CHAPTER 2: Introduction
Description
Fiber 1 has failed
Fiber 1 has passed
Fiber 2 has failed
Fiber 2 has passed
CertiFiber Remote is
transmitting at 850nm
CertiFiber Remote is
transmitting at 1300nm
Low Battery < 10%
Battery 10 to 25%
Battery 25% to 75%
Good Battery > 75%
Part 1 of Two Way
Autotest completed
17
Advertisement
Table of Contents
