Getting Started - Black Box CertiFiber TS655A Manual

character as a
Shift + Enter to select an alphabetic
character as an
highlight will move to the next position in
the field automatically. If you make a
mistake, press F2 (Delete) to erase the
character and back up.
6. Repeat steps 3 through 5 until the field is
completed.
7. Press F1 (OK) or Escape to exit the Edit
screen.

2.9 Getting Started

With CertiFiber, you can certify a fiber link in
seconds using the one-button Autotest. To run
an Autotest, take these steps (see
for more detailed information):
1. Set the reference value (refer to
Section 4.1
2. Remove the covers from the
ST connectors on the CertiFiber and
CertiFiber Remote.
Both units come with covers on their ST connectors to
protect the connectors from dirt and other foreign
matter. Keep the connectors covered when the units
are not in use. This helps to ensure that contaminants
do not affect test measurements.
3. Attach the cable to be tested to CertiFiber
and CertiFiber Remote's ST connectors.
Run one fiber from RX2 to TX2, the
other from TX1 to RX1.
Improperly polished or manufactured fiber-connector
ferrules can damage the CertiFiber's transmit LED. To
avoid out-of-warranty repairs, please use cables with
clean, properly polished ST connectors.
lowercase
uppercase
).
CAUTION!
CAUTION!
CHAPTER 2: Introduction
letter, or press
letter. The
Section 4.2
21