Table of Contents
Advertisement
CERTIFIBER™
2.5.2 T
K
HE
When you turn it on, CertiFiber Remote will
flash the LCD power-up sequence. To save
battery power, CertiFiber Remote will turn off
automatically after 30 minutes without activity.
Battery (CertiFiber Remote)
CertiFiber Remote has a battery-level indicator
that allows you to check the battery if
CertiFiber Remote is not connected to the
CertiFiber main unit. Press the Battery button
to illuminate the RX1 and TX2 LEDs on the
CertiFiber Remote unit. If both LEDs blink
red, the batteries are low and should be
replaced. If the LEDs blink green, the remote
unit's batteries are good and testing can
proceed.
CertiFiber and CertiFiber Remote each require
three AA alkaline batteries. If CertiFiber and
CertiFiber Remote will be stored for more than
one month, the batteries should be removed.
To conserve battery life, CertiFiber will turn off
automatically when no key has been used for
10 minutes.
CertiFiber and CertiFiber Remote will not function
properly with carbon batteries. Alkaline batteries are
required.
Stored Autotests and setup parameters are stored in
flash memory. They are not affected by the battery
status.
18
EYPAD
ON/OFF (CertiFiber Remote)
NOTES
Advertisement
Table of Contents
