Table of Contents
Advertisement
CERTIFIBER™
5.3.2 R
EMOTE
To use the calibrated light source in the
CertiFiber Remote for loss testing or fiber
identification, take these steps:
1. Press and hold the CertiFiber Remote's
Battery button.
2. The RX1 and/or TX2 LEDs slowly flash
five times as the unit performs its battery
test.
3. The Wavelength LED then blinks rapidly
until the Battery button is released.
4. The unit steadily lights the Wavelength
LED to indicate that it is ready to
provude a consistent light source for the
currently selected wavelength.
5. Press and hold the Battery button if you
want to switch to the other wavelength.
6. Press the Battery button to turn the
light source off.
58
Advertisement
Table of Contents
