Setpoints; To Display Or Change Driver Or Set Driver Properties - Carrier i-Vu CCN Pro 4.2 Installation Manual

Setpoints

•
Programmed setpoints are set and changed by operators.
•
Effective setpoints reflect the impact of other system conditions on the programmed setpoints, such as
setpoint adjustments, and hysteresis. Effective setpoints control the equipment.
To change programmed setpoints:
Navigate to a setpoint control in one of the following places:
1
The Space Temperature Setpoints section of the Equipment tab of a Properties page
○
A Graphics page
○
On a programmed setpoint bar, click and drag the segment or the gap between segments you want to
2
change.
Type new values in the Heating and Cooling fields.
3
TIP You can click and drag a segment or a gap between segments to change setpoints.
Click OK.
4

To display or change driver or set driver properties

NOTE Only the Installer role has access to the following.
i-Vu CCN Pro 4.2
Monitor and control equipment
45