Danfoss VLT Profinet MCA 120 Operating Instructions Manual page 73

Warnings and Alarms
No. Description
80 Drive Initialized to Default Value
81 CSIV corrupt
82 CSIV parameter error
85 Profibus/Profisafe Error
90 Encoder Loss
91 Analogue input 54 wrong settings
100-
See Operating Instructions for MCO 305
199
243 Brake IGBT
244 Heatsink temp
245 Heatsink sensor
246 Pwr.card supply
247 Pwr.card temp
248 Illegal PS config
250 New spare part
251 New Type Code
Table 11.1 Alarm/Warning Code List
(X) Dependent on parameter
1) Cannot be Auto reset via 14-20 Reset Mode
A trip is the action when an alarm has appeared. The trip
coasts the motor and can be reset by pressing [Reset] or
by making a reset by a [1] digital input (Parameter group
5-1* Digital I/O Mode ). The event that caused an alarm
cannot damage the frequency converter or cause
dangerous conditions. A trip lock is an action when an
alarm occurs, that can damage the frequency converter or
connected parts. A Trip Lock situation can only be reset by
a power cycling.
MG90U302
Operating Instructions
Warning Alarm/trip
X
(X) (X)
X X
X X
X
X
X
X
X
Table 11.2 LED Indication
Danfoss A/S © Rev. 2014-02-27 All rights reserved.
Alarm/trip lock Parameter reference
17-61 Feedback Signal Monitoring
X S202
X
X
X
X
X
X 14-23 Typecode Setting
X
Warning
Alarm
Trip locked yellow and red
yellow
flashing red
11
71
11