Danfoss VLT Profinet MCA 120 Operating Instructions Manual page 43

PROFINET Acyclic Communicat...
Error code
If the IO device does discover an error during the
execution of the command, it sets the error code to the
following values:
0x00 unknown parameter
0x01 parameter is read-only
0x02 value out of range due to max/min value
0x03 wrong subindex
0x04 parameter is no array
0x05 wrong datatype (wrong data length)
0x06 it is not allowed to set this parameter (only reset)
0x07 descriptive element is read-only
0x09 no description available (only value)
0x0b process control not possible
0x0f no text array available (only value)
0x11 not possible in current state
0x14 value out of range due to drive state/configuration
0x15 reply too long (more than 240 bytes)
0x16 wrong parameter address (unknown or unsupported value
for attribute, element, parameter number or subindex or
illegal combination
0x17 illegal format (for writing)
0x18 value amount not consistent
0x65 wrong axis : action not possible with this axis
0x66 unknown service request
0x67 this service is not possible with multi parameter access
0x68 parameter value can not be read from bus
Table 7.3 Error Code
NOTICE
All values if Hex numbers.
Data
The actual value to transfer. The amount of data has to be
exactly the size requested in the parameter block. If the
size differs, the request generates an error.
MG90U302
Operating Instructions
Danfoss A/S © Rev. 2014-02-27 All rights reserved.
7 7
41