Danfoss VLT Profinet MCA 120 Operating Instructions Manual page 24

How to Configure the System
5 5
Illustration 5.5 Set up the Peripheral Input and Output Data
The configuration tool automatically assigns addresses in
the peripheral address area. In this example the input and
output area have the following configuration:
PPO type 6
PCD word
number
Input 256-257 258-259
address
Set-up STW
Table 5.2 PCD Read (VLT to PLC)
PCD word
number
Output 256-257 258-259
address
Set-up CTW
Table 5.3 PCD Write (PLC to VLT)
22
0 1 2
260-261
MAV 9-16 PCD Read
Configuration.2
0 1 2
260-261
MRV 9-15 PCD Write
Configuration.2
Danfoss A/S © Rev. 2014-02-27 All rights reserved.
Operating Instructions
Assign the PCDs via 9-16 PCD Read Configuration for inputs
and 9-15 PCD Write Configuration for outputs.
Download the configuration file to the PLC. The PROFINET
system should start data exchange when the PLC is set to
Run mode.
3
262-263
9-16 PCD Read
Configuration.3
3
262-263
9-15 PCD Write
Configuration.3
MG90U302