Seat Mii 2019 Owner's Manual page 106

WARNING
The side lights or daytime running lights
are not bright enough to illuminate the road
ahead and to ensure that other road users
are able to see you.
Always use your dipped beam head
●
lights if it is raining or if visibility is poor.
WARNING
If the headlights are set too high and not
used correctly, there is a risk of dazzling or
distracting other road users. This could re-
sult in a serious accident.
Always make sure that the headlights are
●
correctly adjusted.
Note
The legal requirements regarding the use
of vehicle lights in each country must be
observed.
Light and visibility: functions
Parking light remains on both sides
If when switching off the ignition, the light
control remains in the position
hicle is closed from outside, both headlights,
in addition to the side lights and the rear
lights will light up.
104
Daytime running lights
The daytime driving light consists of individu-
al lights in the front headlamps.
When the daytime driving light is switched on,
only the individual lights come on
The daytime lights are switched on each time
the ignition is turned on if the light setting is in
position or in position

WARNING
If the road is not well-lit and the vehicle is
not clearly visible to other drivers, an acci-
dent may occur.
Never use the daytime driving light if the
●
road is not well-lit as a result of the weath-
er conditions and poor visibility. The day-
time driving lights are not bright enough to
illuminate the road ahead and to ensure
that other road users are able to see you.
The rear lights do not come on with the
●
daytime driving light. A vehicle which does
not have the rear lights on may not be visi-
ble to other drivers in the darkness, if it is
raining or in conditions of poor visibility.
Note
The headlights, rear lights and turn signals
and the ve-

may mist up temporarily on the inside in
cool or damp weather. This is normal and in
no way effects the useful life of the vehicle
lighting system.
Operation
›››
.
.

Automatic dipped beam control
*

The automatic dipped beam control is merely
intended as an aid and is not able to recog-
nise all driving situations.
When the light switch is in position
vehicle lights and the instrument panel and
switch lighting switch on and off automatical-
›››
ly in the following situations
visibility: functions on page 104:
Automatic switch- Automatic switch-
ing on ing off
The photo sensor de- When adequate lighting
tects darkness, for exam- is detected.
ple, when driving through
a tunnel.
The rain sensor detects When the windscreen
rain and activates the wipers have been inac-
windscreen wipers. tive for a few minutes.
WARNING
If the road is not well lit and other road
users cannot see the vehicle well enough
or at all, accidents may occur.
The automatic dipped beam control
●
( ) only switches on the dipped beam

when there are no changes in brightness,
and not, for example when it is foggy.
, the

in Light and