Seat Mii 2019 Owner's Manual page 109

Adjusting the headlights
In those countries where vehicles drive on the
other side of the road to the home country,
the asymmetric dipped beam may dazzle
drivers of oncoming vehicles.
For this reason, stickers may be needed to
cover the headlights when driving abroad.
For further information, please refer to a spe-
cialised workshop. SEAT recommends visiting
a technical service.
Note
The use of stickers to cover headlights is
only permitted over a short period. To mod-
ify the direction of the headlamps more
permanently, please take the vehicle to a
specialised workshop. SEAT recommends
taking your car in for technical service.
Lights and visibility
Headlight range control, lighting of
the instrument panel and controls
Next to the steering wheel: Headlight
Fig. 112
range control
Headlamp height adjustment
›››
The headlight range control
modified according to the value of the head-
light beam and the vehicle load status. This
offers the driver optimum visibility and the
headlights do not dazzle oncoming drivers
›››
.
The headlights can only be adjusted when
the dipped beam is switched on.
›››
To reset, turn switch Fig. 112:
Value Vehicle load status
Two front occupants, luggage compart-

ment empty
To reset, turn switch
Value Vehicle load status
All seats occupied, luggage compart-

ment empty
All seats occupied, luggage compart-

ment full.

Driver only, luggage compartment full
a) If the vehicle load does not correspond to those
shown in the table, it is possible to select intermediary
positions.
Instrument and switch lighting
When the side lights or dipped beam head-
lights are switched on, the lighting for instru-
ments and controls lights up at a constant
Fig. 112 is
brightness.
WARNING
Heavy objects in the back of vehicle may
cause headlight dazzle and distract other
drivers. This could result in a serious acci-
dent.
Adjust the light beam to the vehicle load
●
status so that it does not blind other driv-
ers.
a)
›››
Fig. 112:
a)
107