100 Mbit/S F/O Port; Aui Port - Hirschmann MICE MS20-1600 Series User Manual

2.12.4

100 Mbit/s F/O port

This port is an MTRJ, ST, or DSC socket.
The 100 Mbit/s F/O port offers you the ability to connect network components
according to the IEEE 802.3 100BASE-FX standard.
This port supports:
 Full or half duplex mode
Default setting: Full duplex
Note: Make sure that the LH ports are connected exclusively with LH ports,
SM ports exclusively with SM ports, and MM ports exclusively with MM ports.
2.12.5 1000 Mbit/s F/O port
This port is an LC socket.
The 1000 Mbit/s F/O port offers you the ability to connect network
components according to the IEEE 802.3 100BASE-SX/1000BASE-LX
standard.
This port supports:
 Autonegotiation
 Full duplex mode
Delivery state: autonegotiation activated
Note: Make sure that you connect LH ports exclusively with LH ports, SX
ports exclusively with SX ports, and LX ports exclusively with LX ports.
1000 Mbit/s F/O ports (LC sockets) enable the connection of terminal devices
or independent network segments in compliance with the IEEE 802.3-2000
(ISO/IEC 8802-3:2000) 1000BASE-SX or 1000BASE-LX standards.
Connect the ports of the media modules plugged into the basic module as
required in order to set up your industrial Ethernet or expand your existing
network.
 Install the data lines according to your requirements.
2.12.6

AUI port

The housing of the Sub-D plug is electrically isolated from the lower panel of
the device.
The AUI (Attachment Unit Interface) port offers you the opportunity to
connect a device via an AUI cable according to IEEE 802.3.
This port supports:

SQE test

DTE Power Monitor
Default setting: SQE test function and DTEPower monitor function is not
active.
Installation MS20/MS30
Release 11 07/2013
45