Installing The Device On The Din Rail, Grounding; Mounting On The Din Rail - Hirschmann MICE MS20-1600 Series User Manual

2.11 Installing the device on the DIN rail,
grounding
2.11.1

Mounting on the DIN rail

 Mount the device on a 35 mm DIN rail in accordance with DIN EN 60175.
 Attach the upper snap-in guide of the device into the DIN rail and press
the device down against the DIN rail until it snaps into place.
Note: The shielding ground of the industrial connectable twisted pair lines is
connected to the lower panel as a conductor.
Figure 18: Assembly
2.11.2 Grounding
The lower panel of the device housing is grounded by means of the DIN rail
and optionally by means of the separate ground screw
42
(see figure 2).
Installation MS20/MS30
Release 11 07/2013