Connecting The Mm22-T1T1T1T1 Poe Media Module; Adjusting The Dip Switch Settings On The Mm20-A8A89999Sahh Media Module - Hirschmann MICE MS20-1600 Series User Manual

OFF ON
4
5
6
7 8
Figure 15: 3-pin DIP switch on the MICE basic module MS20/MS30-...E...
1 - Switch 1, position ON, Function: Redundancy Manager (RM)
2 - Switch 2, position ON, Function: Mod. 1 Port 1 & Mod. 2 Port 1
3 - Switch 3, position ON, Function: Stand-by
4 - Switch 1, position OFF, Function: -
5 - Switch 2, position OFF, Function: Ring Port: Mod. 1 Port 1 & 2
6 - Switch 3, position OFF, Function: -
7 - Switch position OFF
8 - Switch position ON
 Before starting operation of the device, check whether the default settings
of the DIP switch correspond to your requirements.
2.7 Adjusting the DIP switch settings on the
MM20-A8A89999SAHH media module
With the 3-pin DIP switch in the bottom panel of the MM20-A8A89999SAHH
media module, you enter settings for the SQE test function and for monitoring
the DTE voltage.
Note: Before starting operation, check whether the device in question
operates the transceiver with or without an SQE test.
 Before starting operation of the device, check whether the default settings
of the DIP switch correspond to your requirements.
2.8 Connecting the MM22-T1T1T1T1 PoE media
module
The MM22-T1T1T1T1 PoE media module with PoE voltage (48 V DC safety
extra-low voltage) is supplied with power via an external power supply unit.
The PoE voltage is fed into the 3-pin terminal block of the PoE media module.
The twisted-pair cables at ports 1 to 4 are supplied with PoE voltage via the
spare pairs (pins 4 & 5 and 7 & 8 of the RJ45 sockets).
Installation MS20/MS30
Release 11 07/2013
1
2
3
37