Cancel Auto Start - DeltaOHM HD32.1 Operating Manual

NOTE: By default the acquisition end time is 10 minutes after the logging session start time.
8. Once both values have been set, a summary will be displayed: Start and end time of the LOG
session.
9. Press ENTER to confirm or ESC to exit without enabling the automatic start: In both cases, you
will return to the LOGGING menu.
10. Press SETUP to exit immediately from the main menu.
When the instrument starts automatically a LOG session, a beep is issued on each capture and the
blinking LOG message is shown at the top of the display.
Press MEM to stop the session before the set time.
To cancel the automatic start setting, use the Cancel auto start function as illustrated in the
following paragraph.
NOTE: The automatic logging session is started even when the instrument is off . If it is off
when the automatic logging session is started, the instrument is turned on few seconds earlier and
remains on at the end of logging. If it is powered by the battery, it is turned off when idle for some
minutes at the end of the logging session.
See paragraph 4.2.2 to set the automatic shut off.

5.2.4 Cancel auto start

Once the LOG session start and end times are set, you can prevent the session automatic start by
using Cancel auto start.
Once you have accessed the LOGGING submenu:
1. Use the arrow keys ▲ ▼ to select Cancel auto start
2. The LOG session start and end times will be displayed:
HD32.1
- 39 -
V2.1