Instrument Setup; Start Of A New Logging Session - DeltaOHM HD32.1 Operating Manual

Thermal microclimate

Table of Contents

NOTE: Once selected, for example max, all displayed quantities represent the maximum value.

The average is calculated on the first five minutes of samples, and then on the current

average.

The F3 key allows choosing to clear (Clr) the maximum, minimum and average data of the

captured measurements:

1. In order to clear the data, select Clr with F3 ;

2. Another drop-down menu will open;

3. Use the arrow keys ▲▼ to select yes;

4. Press ENTER to confirm.

5. Press ESC or select no, to exit without clearing the data.

4.1.7 Instrument Setup

In order to set the instrument, you have to open the main menu by pressing SETUP . See the next

chapter for further details.

Press MEM to start a Logging session: This key starts and stops the logging of a data block to be

saved in the instrument's internal memory. The data logging frequency is set in the "Log interval"

menu parameter. The data logged between a start and subsequent stop represent a measurement

block.

When the logging function is on, the LOG indication is displayed, the battery symbol blinks and a

beep is issued each time a logging occurs.

To end the logging, press MEM again.

The instrument can turn off during logging between one capture and the next: The function is

controlled by the Auto_shut_off_Mode parameter. When the logging interval is less than one

minute, the logging instrument remains on; with an interval of at least one minute, it turns off

between one capture and the next.

- 30 -

HD32.1

V2.1

Table of Contents