Automatic Document Feeder - Sharp MX-M6570 User Manual

Digital multifunctional system

Hide thumbs Also See for MX-M6570:

Table of Contents

BEFORE USING THE MACHINE►HOW TO PLACE THE ORIGINAL

AUTOMATIC DOCUMENT FEEDER

This section explains how to place originals in the automatic document feeder.

• Place originals of different sizes together, if needed, in the automatic document feeder. In that case, use the "Others"

function in each mode to set [Mixed Size Original]. An original cannot be detected if all pages are of the same size but

some of them are set in a different orientation.

5-1/2" x 8-1/2" (B5)

8-1/2" x 11" (A4)

• Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips.

• If originals have damp spots due to correction fluid, ink or paste up glue, wait until the originals are dry before making

copies. Otherwise the interior of the machine or the document glass may be soiled.

• Do not use the following originals. Incorrect original size detection, original misfeeds, and smudges may result.

Transparency film or other transparent material for backup copy, tracing paper, carbon paper, thermal paper or originals

printed with thermal transfer ink ribbon should not be fed through the document feeder. Originals to be fed through the

feeder should not be damaged, crumpled, folded, loosely pasted together, or have cut-out holes. Originals with multiple

punched holes other than two-hole or three-hole punched paper may not feed correctly.

• When using originals with two or three holes, place them so that the punched edge is at a position away from the feed slot

of the document feeder tray. Specify the orientation of the original using [Original].

• For a thin original (9 lbs. to 14 lbs. (35 g/m

scanning is disabled.

Hole positions

)), use [Slow Scan Mode] in the "Others". For this type, 2-sided

Table of Contents