Documenting The Configuration Settings - Assa Abloy Securitron Magnalock M670BD Series Installation Instructions Manual

Documenting the Configuration Settings

NOTE: The Board Settings are now complete.
1. COPY the settings onto the adhesive-backed circuit board settings label enclosed with the mounting
hardware packet. (See Figure 4, "M670/M680 Settings").
NOTE 1: The figure above shows the Default settings. Settings may vary based on checklist.
NOTE 2: The settings information is required if the Magnalock needs to be inspected, serviced, or
replaced.
2. COMPLETE the label and AFFIX to the inside cover of the Magnalock (see Figure 5, "Magnalock
Settings Label."
Figure 4. M670/M680 Settings
Figure 5. Magnalock Settings Label
Page 8
PN# 500-10550
Rev. D, 12/14