Before Turning The Power On; Things To Check Before Turning The Power On - Panasonic FP-M Hardware Manual

5-2. Before Turning the Power ON

5-2. Before Turning the Power ON

1. Things to Check Before Turning the Power ON

• After wiring, be sure to check these items before turning the power ON.
Check item
Board
Power Supply
Wiring
Setting of control board
Setting of expansion
board
Memory
(EPROM and EEPROM)
78
Description
• Does the board type match the design list ?
• Are the mounting screws properly tightened ?
• Do the spacer types match the boards ?
• Is operating voltage supplied correctly ?
• Is the wire size correct ?
• Does the wiring of connector and terminal match ?
• Is the operating voltage of I/O correct ?
• Are the expansion power supply cables properly
connected ?
• Is the wire size correct ?
• Is the mode selector set to the PROG. mode ?
• Is the backup battery properly inserted in the holder ?
• Is the baud rate selector set correctly ?
• Is the I/O address setting switch on the expansion
board set correctly ?
• Aren't the I/O addresses overlapping ?
• Is the memory (EEPROM or EPROM) properly
attached ?
• Does the memory type match the position of memory
selector ?
Page to see
page 42 and 43
page 46 and 47
page 48 to 62
page 22 to 27, 84,
100 and 125
page 106 and 107