Allocation Of High-Speed Counter Board - Panasonic FP-M Hardware Manual

Board type
D/A converter board
Notes:
• Refer to page 201, "8-7. Special Data Registers", for details about special data registers.
• When two or more of these boards are installed, be sure to configure the board number selector in order
to prevent special data register overlap. The board number selectors are set to board number 0 (all "OFF"
position) when shipped.
• Board number selector upper state is "OFF ( )" and the lower state is "ON ( )".

4. Allocation of High-speed Counter Board

• The data for the high-speed counter board are stored in specially selected data registers (DT9104 to DT9121).
• The data for these boards are stored in special data registers as follows.
Board type
High-speed counter
board
Board Board number selector
number position
No. 0
OFF OFF OFF OFF
ON
1 2
No. 1
ON OFF OFF OFF
ON
1 2
No. 2
OFF ON OFF OFF
ON
1 2
No. 3
ON ON OFF OFF
ON 1 2
Channel number
Channel 0 Target value 0
Target value 1
Elapsed value
Capture value
Channel 1 Target value 0
Target value 1
Elapsed value
Capture value
Channels 0 and 1 Control area
Status monitor register area
Input/output
Analog output
3 4
Analog output
3 4
Analog output
3 4
Analog output
3 4
Data type
8-3. I/O Allocation Table
Channel Special data
number register
0 DT9096
1 DT9097
0 DT9098
1 DT9099
0 DT9100
1 DT9101
0 DT9102
1 DT9103
Special data register
DT9104 and DT9105
DT9106 and DT9107
DT9108 and DT9109
DT9110 and DT9111
DT9112 and DT9113
DT9114 and DT9115
DT9116 and DT9117
DT9118 and DT9119
DT9120
DT9121
183