Programming With Fp Programmer Ii; System Configuration - Panasonic FP-M Hardware Manual

5-5. Programming with FP Programmer II

5-5. Programming with FP Programmer II

The FP Programmer II performs program entry, editing, and monitoring of FP series programmable controllers.

1. System Configuration

Connection between an FP-M control board and an FP Programmer II
• An FP-M peripheral cable (for FP Programmer II) is required to connect an FP-M control board to an FP
Programmer II.
Setting of FP-M control board
• Set the baud rate selector of the FP-M control board to 19200.
100
Baud rate selector
9600
19200
V0 V1
9600
19200
FP-M peripheral cable (for FP Programmer II)
(
AFC8521: 1 m/3.281 ft.
AFC8523: 3 m/9.843 ft.
FP PROGRAMMER
ST AN OR OT FN/P
X•WX Y•WY R•WR L•WL FL
NOT STK TM CT (BIN)
T•SV
DT/Ld IX/IY C•EV K/H
FP Programmer II
= < >
D SHIFT
C D E F SC
(AFP1114)
(-)
8 9 A B
OP
SRC
4 5 6 7
READ
0 1 2 3
(HELP) (DELT)
ACLR ENT WRT
CLR INST
Mode selector
RUN REMOTE PROG.
(BATT.)
EPROM EEPROM
RUN PROG. ERR ALARM.
RUN REMOTE PROG.
)