1) From the 1/2 in. jumper ass'y between RRH-2WB and the RF antenna 1/2 in. jumper ass'y, install one
end of the cable, which the miniature Din-type male connector is connected to, to the RF port at the
bottom of RRH-2WB.
2) Attach the heat shrink tube (jelly type) for finishing to the Jumper cable, and connect the miniature Din-
type male connector to the RF port.
3) After connecting the connector, finish the connection with a heat shrink tube (jelly type).
© SAMSUNG Electronics Co., Ltd.
Mobile WiMAX/TD-LTE RRH-2WB Installation Manual/Ver.2.0
Miniature Din Type- Male Connector
(For 1/2 in. Feeder Line)
RF Cable (1/2 in. Feeder Line)
Heat Shrink Tube (Jelly Type, Black)
Heat Shrink Tube (Jelly Type, Black)
Heat Shrink Tube (Jelly Type, Black)
Figure 3.13 Connection of Feeder Cable (Detail A)
Detail 'A'
3-23