ANNEX C. Connector Assembly
Heating Gun
C-10
Heat Shrink Tube
Figure C.9 Shrinking the Heat Shrink Tube_Feeder Line (2)
4) Holding one end of the heat shrink tube with your
hand, apply heat starting from the connector using
the heating gun.
5) Rotate the heating gun so that heat is evenly
distributed to prevent that bubbles are generated or
heat is concentrated to a specific part.
6) Shrink the heat shrink tube until jelly appears at the
end part of it (refer the Figure below) and finish it.
© SAMSUNG Electronics Co., Ltd.
Jelly