Table 3.1 Recommended Minimum Allowed Cable Bend Radius - Samsung RRH-2WB Installation Manual

Mobile wimax/td-lte

page of 141

/ 141
Contents
Table of Contents
Bookmarks

Table of Contents

GV/CV/FR-8

Optic Cable

UTP/FTP/S-FTP Cable

1/2 in. Feeder Line (Indoor)

1/2 in. Feeder Line (Outdoor)

7/8 in. Feeder Line (Outdoor)

1-1/4 in. Feeder Line (Outdoor)

1-5/8 in. Feeder Line (Outdoor)

LMR-400

RG-316D

※ If the allowed cable bend radius is specified by the manufacturer, comply with the bend radius specified.

Cable Binding

Cable binding involves fixing and arranging an installed cable using binding strings, cable

ties, binding lines, and ram clamps, etc.

Follow these guidelines when binding a cable.



Be careful not to damage the cable during binding.



Use appropriate cable binding tools according to the target location (indoor or outdoor,

etc.) and the use of the cable (power supply cable, optical cable, feeder line, etc.).



Do not let the cutting section of a cable tie and binding line, etc. be exposed to the

outside. This may cause damage to cables or personal injury. Make sure that the

cutting sections of cables are not exposed to the outside.



If there is a danger that contact failure may occur in a connector connection due to

tension, install the cable as short as possible.

Connector Attachment

Connector attachment involves assembling a connector to an installed cable or to a device

on the site.

Follow these guidelines when attaching a connector.



Make sure you are fully aware of the connector assembly method before assembling a

connector. Assemble the connector in accordance with its pin map.



Each connector has a hook to prevent its core positions from being changed.

Check the corresponding grooves before connecting a connector to another connector.



Trim the remaining string of any knot in a binding string so that the knot does not loosen.