How To Shrink The Heat Shrink Tube; When Assembling A Connector To The Feeder Line - Samsung RRH-2WB Installation Manual

C.4 How to Shrink the Heat Shrink Tube
C.4.1 When Assembling a Connector to the Feeder Line
Below is the procedure for shrinking the heat shrink tube.
1/2 in. Feeder Line
© SAMSUNG Electronics Co., Ltd.
Mobile WiMAX/TD-LTE RRH-2WB Installation Manual/Ver.2.0
Figure C.8 Shrinking the Heat Shrink Tube_Feeder Line (1)
1) Prepare a 1/2 in. feeder line, heat shrink tube, and
heating gun to finish the cable using a heat shrink
tube.
1/2 in. Connector
Heat Shrink Tube (Jelly Type)
28/6 × 150 mm (5.9 in.)
Heating Gun
2) Insert the heat shrink tube into the 1/2 in. feeder
line, and then place the heat shrink tube at the end
of the cutting area of the connector where the tool
will be used.
Cutting Area
3) Set the heating gun to 250 to 300°C. (482~572°F)
C-9