Table of Contents
Advertisement
ANNEX C. Connector Assembly
1) The components of the N type-male are an N type-male body, an insert ring, a clamping nut, O-ring, and a heat
shrink tube, and it is assembled using the wire stripper, trimming tool, spanner, etc.
O-Ring
Clamping Nut
2) Using a stripping tool or a knife, strip the 1/2 in. feeder line by 25 mm (0.98 in.) from the end, as shown in the
figure below.
Figure C.1 Assembling the N type-male (1/2 in. Feeder Line) Connector (1)
C-2
Insert Ring
25 mm
Heat Shrink Tube [28 mm (1.1 in.)]
N type-Male Body
1/2 in. Feeder Line
Trimming Tool
1/2 in. Feeder Line Conductor
1/2 in. Feeder Line Jacket
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
