Table of Contents
Advertisement
ANNEX C. Connector Assembly
C.3 Finishing the Connector Connection Part by
Tape
Finishing the connector connection part by tape (insulation tape, rubber tape, etc.) in the
outdoor environment is as follows:
1) Overlap the exposed part of the connector connection part using rubber tape (Keep a distance as the
half size of rubber tape) and press it with your hands lightly to make rubber tape adhere well.
2) Wrap the part where the rubber tape is attached using insulation tape two times or more. When cutting
off the tape, cut it off neatly using a cutting device such as scissors or a knife.
3) Bind the end part of the insulation tape using cable tie to prevent slips.
Rubber Tape
Insulation Tape
C-8
Cable Tie
Figure C.7 Finishing the Connector Connection Part by Tape
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
