Table of Contents
Advertisement
ANNEX B. Installing Feeder Cable
B.2 Antenna Feeder Cable Ground
Ground the antenna feeder line using the grounding kit located under the Tower Ground
Bar (TGB) installed in the lower section of the tower or in the antenna feeder line duct.
The procedure for connecting the ground kit to the feeder line is as follows:
Ground Kit
1) Remove about 55 mm (2.17 in.) of the sheath of cable when the 7/8 in. feeder cable is used.
2) Open it by returning hook of the clamp fixing for Ground kit in the left direction.
1
B-4
Insulation Tape
Rubber Tape
2
Figure B.1 Feeder Cable Grounding (1)
M6 × 25L Hex. Bolt
M6 Spring Washer
M6 Plane Washer
M6 Plane Washer
M6 Spring Washer
M6 Hex. Nut
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
