Table of Contents
Advertisement
5) Tighten firmly the clamping nut and Din type-male body inserted to the 1/2 in. feeder line using a wrench.
The recommended torque for tightening the clamping nut and Din type-male body is 30~50 N.m
(306~510 lbf·ft) (Note that it should only be tightened by rotating the external body with the clamping nut
in a fixed and stable position.)
Din type-Male Body
6) Insert the heat shrink tube [28 mm/10 cm (1.10 in./3.94 in.)] to the 1/2 in. feeder line fitted with the Din
type-male connector; and shrink the heat shrink tube inserted into the feeder line using a heating gun.
Figure C.6 Assembling the Din type-male (1/2 in. Feeder Line) Connector (2)
Checking to carry out when assembling the Din type-male connector
The shape, tool and assembly method may differ depending on the connector
type and manufacturer. Make sure to check the user manual provided by the
manufacturer before assembling.
© SAMSUNG Electronics Co., Ltd.
Mobile WiMAX/TD-LTE RRH-2WB Installation Manual/Ver.2.0
Heat Shrink Tube
Spanner (keep the fixed state)
Clamping Nut
Heating Gun
C-7
Advertisement
Table of Contents
