Type Designation; Type Designation Emix23 - ELGO Electronic EMIX23 series Operating Manual

10 Type Designation

10.1 Type Designation EMIX23

EMIX23
Series/Type:
EMIX23
Linear encoder
Version No.:
000 = Standard version
Signal cable length (in m):
01.5 = 1.5 m standard length
Resolution in µm:
0001 = 0.001 mm at 4 edge triggering
Power supply / output levels:
00 = 10-30 VDC / 10-30 V-HTL
01 = 10-30 VDC / 5 V-TTL
11 = 5 VDC / 5 V-TTL
Options:
D1 = Connection by 9 pin D-SUB, ELGO standard assignment
D3 = Connection by round connector (compatible with SKA1 signal cable)
L = Vertical position of the sensor*
R = With free defineable single reference pulse
E = LED > green LED = reading distance is ok / red LED = reading distance is not ok.**
* Option L cannot be combined with Option R
** Currently only available with power supply: 5 VDC / output levels: 5 V-TTL
NOTE
When ordering, please use the here described ordering code (Type Designation).
Options that are not required are filled in with „-„.
10.1.1 Ordering Examples for EMIX23
EMIX23-000-01.5-0001-00
EMIX23 standard, with 1.5 m signal cable, 0.001 mm resolution, 10 ... 30 VDC power supply,
output levels HTL, connections via pre-assembled cables (open wires)
EMIX23-000-01.5-0001-00-D1-R-E
EMIX23 standard, with 1.5 m signal cable, 0.001 mm resolution, 10 ... 30 VDC power supply,
output levels HTL, connections via 9pin. D-SUB, reference pulse and LED for reading distance
EMIX23-000-01.5-0005-11
EMIX23 standard, with 1.5 m signal cable, 0.005 mm resolution, 5 VDC power supply,
output levels TTL, connections via pre-assembled cables (open wires)
XXX XX.X
AAA BB.B
- 24 -
XXXX XX
CCCC DD
Type Designation
X
E