Husky Altanium Neo5 User Manual page 81

Table of Contents

Advertisement

User Guide
Remote Standby Operational Description
Manual
----
----
----
----
----
----
----
----
----
----
----
To cancel the remote standby duration timer at any time, touch the Start or Stop buttons
(only when in the Trigger or ON/OFF modes).
Reset Delay Timer in Direct Mode:
The Reset Delay Timer is only used when in Direct Mode and while the delay timer is in
progress.
If enabled,
Standby button in the system header.
Delay Time
Time
0:00:00
0:00:00
0:00:00
X:XX:XX
X:XX:XX
X:XX:XX
X:XX:XX
0:00:00
X:XX:XX
X:XX:XX
X:XX:XX
0:00:00
0:00:00
0:00:00
0:00:00
X:XX:XX
X:XX:XX
X:XX:XX
X:XX:XX
0:00:00
----
----
, the Reset Delay Timer allows you to reset the delay timer by touching the
v 1.0 — August 2018
Remote
Input Mode
Time
Trigger
System will not enter Standby since no
timers are set.
Trigger
System immediately enters and remains in
Standby until the timer expires.
Trigger
System delays for specified time and then
enters Standby until the timer expires.
Trigger
System delays for specified time and then
enters Standby indefinitely.
Trigger
System delays for specified time and then
enters Standby until the timer expires. If the
input signal changes state while delay timer
is active, the delay timer is reset to the
specified value.
Trigger
System delays for specified time and then
enters Standby indefinitely. If the input
signal changes state while the delay timer is
active, the delay timer is reset to the
specified value.
ON/OFF
System enters Standby until the input signal
is not active.
ON/OFF
System enters Standby until the input signal
is not active or the timer expires.
ON/OFF
System delays for specified time and then
enters Standby until the signal is not active
or the timer expires.
ON/OFF
System delays for specified time and then
enters Standby until the input signal is not
active.
Direct
System enters Standby until the input signal
is not active. If the input signal is active
when the system is started, it will
immediately go into Standby mode.
Operation - STANDBY Button Select
Altanium Neo5
Page 71

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents