Safety Signs - Husky Altanium Neo5 User Manual

•
•
•
•
•
•
•
CAUTION!
Mechanical hazard – risk of damage to the equipment. NEVER allow the fan inlets or
outlets on the unit to become blocked. Insufficient cooling airflow through the fan
inlets and outlets could damage the system.
CAUTION!
When switching OFF the system wait 30 seconds before switching the main disconnect
back ON. If you do not wait the required 30 seconds, communication issues may occur.
1.1.1

Safety Signs

Safety signs clearly mark potentially hazardous areas in or around equipment. For the safety
of personnel involved in equipment installation, operation and maintenance, use the
following guidelines:
The following safety symbol may appear on safety signs:
NOTE:
Page 2
The system should only be installed by qualified personnel in accordance with local
codes.
When the controller is connected to an injection molding machine, the safety of the
system is the responsibility of the integrator.
Only persons with a thorough knowledge of the system's operation and capabilities
should operate the system.
Read all of these instructions before connecting power and turning on the system.
Follow all warnings and instructions marked on the system.
Unless specifically explained in this manual or directed by Husky, do not attempt to
repair the system. Doing so could result in damage to the system, or serious personal
injury.
Only use the specified input supply voltage that is indicated on the identification label
attached to the power input cable and/or the cabinet
NOTE: If unsure of the appropriate supply voltage, call the nearest Husky Regional
Service and Sales office.
Safety signs may include a detailed explanation of the potential hazard and
associated consequences.
v 1.0 — August 2018 Altanium Neo5