Adjustments - Rikon Power Tools 30-120 Operator's Manual

TABLE ADJUSTMENTS
RAISING AND LOWERING THE TABLE
1. Loosen the column lock (A-Fig. 19) on the
table support bracket (B-Fig. 19).
2. Turn the crank to raise or lower the table to the
desired height.
3. Tighten the column lock (A-Fig. 19).
NOTE: The table can rotate 360
the table lock handle and turning to the desired
position. (Fig. 20)
TILTING THE TABLE
1. Loosen the nut below the table support
arm. (Fig. 18). This requires a 24mm socket,
adjustable, or special wrench (see page 17).
2. Tilt the table to the desired angle. (Fig. 21).
3. A tilt scale and pointer are provided on the
bracket to indicate the angle. (Fig. 18).
4. Tighten nut below the table support arm to
secure the table in the angled position.
CHANGING SPINDLE SPEEDS
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN THE
OFF POSITION UNTIL ALL ADJUSTMENTS ARE COMPLETE.
1. Turn off and disconnect the power to the Drill
Press.
2. Open the top belt cover.
3. Release the tension on the belt by loosening
the belt tension lock (A-Fig. 22) and pull the
tension handle backward on the motor (B-Fig.
22).
4. Choose the desired speed by referring to the
speed selection chart that is applied inside of
the top belt cover. Also, see chart on page 14.

ADJUSTMENTS

o
by loosening
CONTINUED ON NEXT PAGE
A
A
B
13
B
Figure 19
Figure 20
Figure 21
Figure 22