Table of Contents
Advertisement
HEAD ASSEMBLY
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
2. Align the drill press head (A-Fig. 6) with the
base of the drill press (B-Fig. 6).
3. Tighten the drill press head (A-Fig. 7) to the
column (B-Fig. 7) by tightening the two set
screws on the right side of the head as shown.
4. Attach the 3 feed handles into the threaded
holes in the handle hub. Fig. 8
5. Install the small, belt cover Handle Knob onto
the right side of the top lid
the belt cover and insert the Phillips head
screw through the hole in the lid from the
inside. Thread the handle on the outside of the
belt cover and tighten it in place with a screw-
driver.
6. Install the idler pulley and drive belts. Simply
slide the pivot post of the idler pulley into the
corresponding hole in the drill press head as
shown. The small drive belt (M24) is mounted
to the spindle pulley and the large drive belt
(M25) is mounted to the motor pulley. Fig. 9.
NOTE: Setting the Spindle Speed and Tension
of the drive belts is covered on pages 13
and 14.
ASSEMBLY
- CONTINUED
(A-Fig.
9). Open
A
A
10
A
A
B
B
Figure 6
B
Figure 7
Figure 8
Figure 9
Advertisement
Table of Contents
