Table of Contents
Advertisement
REMOVING THE CHUCK
1. Open the chuck jaws as wide as possible to
prevent damage.
2. Lower the spindle until the slot in the spindle is
exposed. (Fig. 14)
3. Position the table approximately 1/2" below
the extended chuck.
4. Turn the chuck until a through hole is exposed
in the spindle.
5. Insert the Key-drift into the slot. (Fig. 15).
6. Gently tap the key-drift with a mallet to release
the chuck.
NOTE: To avoid damage to the chuck, make
sure to place a hand below the chuck to catch
it as it is released from the spindle.
INSTALLING THE TABLE
1. Insert the table post (A-Fig. 16) into the table
support bracket (B-Fig.16) as shown.
2. Tighten the locking lever (A-Fig. 17) onto the
table support bracket (B-Fig. 17) and install the
table raising/lowering handle (C-Fig. 17).
3. Check the column & table support arm to make
sure the scale is on zero position (A-Fig. 16).
If necessary, loosen the hex bolt (B-Fig. 16) and
also adjust the hex socket screw (C-Fig. 16) to
level the table 90 degree to the spindle.
A
B
C
Figure 18
ASSEMBLY
PLUGGED IN AND THE POWER SWITCH MUST BE IN THE
OFF POSITION UNTIL ALL ADJUSTMENTS ARE COMPLETE.
A
12
Figure 14
THE MACHINE MUST NOT BE
Figure 15
B
Figure 16
B
Figure 17
A
C
Advertisement
Table of Contents
