Assembly Instructions - Body Solid S2LEC Assembly Instructions & Owner's Manual

S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Frame A (A) to Frame B (B) using:
2 - (#4) M10X105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#40) M10 Nylon Lock Nut
1B. Attach Frame B (B) to Frame C (C) using:
2 - (#4) M10X105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#40) M10 Nylon Lock Nut
1C. Attach Frame D (D) to Frame A (A) using:
2 - (#4) M10X105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#40) M10 Nylon Lock Nut
1D. Attach Frame D (D) to Frame C (C) using:
2 - (#9) M10X80mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#40) M10 Nylon Lock Nut
1E. Attach Frame E (E) to Frame B (B) using:
2 - (#5) M10X25mm Hex Head Bolt
2 - (#51) M10 Flat Washer
1F. Attach Frame E (E) to Frame C (C) using:
2 - (#4) M10X105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#40) M10 Nylon Lock Nut
24