Advertisement
S T E P
7
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
STEP
7B. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tighten to fully go on.
7A. Attach Handle Bars (G & H) to Frame A (A) using:
2 - (#3) M10X100mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#40) M10 Nylon Lock Nut
7B. Insert End Rings (#81), Foam Rollers (#79) and one Cap (#67) into
the Ankle Adjuster (L) & Leg Hold Down (Q) in the sequence shown
in Step 7 Drawing. Secure it by tighten in the Set Screws (#19)
36
Advertisement
