Advertisement
S T E P
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
STEP
4H. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tighten to fully go on.
4A. Install Chrome Guide Rods (WD) into the holes in the Weight Stack
Frame (WA).
Note: Install the rod ends with side holes into the bottom section
of the Weight Stack Frame
4B. Install Rubber Donuts (#80) and slide to the bottom of the Guide Rods
4C. Tilt Guide Rods (WD) away from the Weight Stack Frame (WA) and
install weight plates (#110). Be careful to hold guide rods
steadily when installing weight plates.
Note: Please make sure the grooves of the weight plates are faced
down during installation.
4D. Install Top Plate & Selector Rod Assembly (#18, #55, #60, #61) onto
the Guide Rods .
4E.
Install the Selector Rod Top Bolt (#62), the 1/2" Lock Nut (#44) and the
1/2" Spring Washer (#56) onto the Top Plate (#60).
4F. Install Shaft Collars (#83) onto the Guide Rods so they are directly
below the guide rod holes in the upper section of the Weight Stack
Frame.
4G. Slide Shaft Collars (#83) upward so they lock the guide rods into
position by tightening the M8x8mm Set Screws (#13)
4H. Install Weight Stack Pin (#71) using the key ring end through the
Selector Rod Top Bolt (#62).
30
Advertisement
