Root Level Commands; Digitize; Stop; Stream - Keysight M8131A User Manual

4 Remote Programming

Root Level Commands

:DIGitize

:STOP

:STReam

:SSTReam

106
The Root Level commands control many of the basic operations of the
digitizer.
Command
:DIGitize
The command initializes the selected channels, then starts acquisition of
ADC samples into capture memory. When all waveforms are completely
acquired, the acquisition is stopped.
Command
:STOP
The command causes the digitizer to stop acquiring data into capture
memory.
Command
:STReam
This command is only available with option STR. It starts ODI streaming on
all ports, that are activated and for which the data producer is activated.
See commands
:ODI:PRODucer<N>:ACTivate
Conversion) is switched on, IQ samples are streamed. If the DDC is
switched off, raw data samples are streamed.
Command
:SSTReam
This command is only available with option STR. It stops ODI streaming on
all ports.
:ODI:PORT<N>:ACTivate
on page 127. If the DDC (Digital Down
Keysight M8131A 16/32 GSa/s Digitizer User's Guide
on page 122 and