Table of Contents
Advertisement
The following table describes the parameters of this page:
Field
WAN Physical Type
Default Route Selection
VPI
VCI
Encapsulation
Channel Mode
Enable NAPT
Enable IGMP
PPP Settings
User Name
Password
Type
Idle Time (min)
WAN IP Settings
Type
Description
You can select ADSL WAN or Ethernet
WAN.
You can select Auto or Specified.
The virtual path between two points in an
ATM network, ranging from 0 to 255.
The virtual channel between two points in an
ATM network, ranging from 32 to 65535 (1 to
31 are reserved for known protocols)
You can choose LLC and VC-Mux.
You can choose 1483 Bridged, 1483 MER,
PPPoE, PPPoA, 1483 Routed or IPoA.
Select it to enable Network Address Port
Translation (NAPT) function. When it is
unselected, to access the Internet normally,
you must add a route on the uplink
equipment. Otherwise, the access to the
Internet will fail. Usually it is enabled.
You can enable or disable Internet Group
Management Protocol (IGMP) function.
For PPP dial-up, enter the user name
provided by your ISP.
For PPP dial-up, enter the password provided
by your ISP.
You can choose Continuous, Connect on
Demand, or Manual.
If Connect on Demand is set, you need to
enter the idle timeout time. Within the preset
minutes, if the router does not detect the flow
of the user continuously, it will automatically
disconnect the PPPoE connection.
You can choose Fixed IP or DHCP.
22
Advertisement
Table of Contents
