Problem Solving Guide - Miele DGC 6300 Operating And Installation Instructions

Problem solving guide

With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
The following guide may help you to find the reason for a fault, and to correct it.
You should, however, note the following:
,
Installation work and repairs to electrical appliances must only be carried
out by a suitably qualified person in strict accordance with current local and
national safety regulations. Repairs and other work by unqualified persons
could be dangerous.
Problem
You cannot switch
the appliance on.
The appliance is in
demo mode and is
not heating up.
The fan can still be
heard after the
appliance has
been switched off.
140
Possible cause and remedy
The mains fuse has tripped.
^ Reset the trip switch in the mains fuse box or replace the
fuse (minimum fuse rating - see data plate).
There may be a technical fault.
^ Disconnect the appliance from the electricity supply for
approx. 1 minute.
If, after resetting the trip switch in the mains fuse box and
switching the appliance back on, the appliance will still not
heat up, contact a qualified electrician or the Miele Service
Department.
^ Switch demo mode off and follow the instructions in the
display.
The appliance is fitted with a fan which removes steam from
the oven. The fan will continue to run for a while after the
appliance has been switched off. It will switch itself off
automatically after a while.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.