Auxiliary Input Socket; Charging With Usb Socket - Sangean U4 DBT+ Manual

Auxiliary input socket

A 3.5mm Auxiliary input socket is provided on the right side of your radio to permit an audio signal to
be fed into the unit from an external audio device such as an iPod, MP3 or CD player.
1.
Connect a stereo or mono audio source (for example, iPod, MP3 or CD player) to the Auxiliary
input socket (marked 'Aux In').
2.
Press the Power to switch on your radio.
3.
Press the Source button until the Auxiliary Input band is selected.
4.
Adjust the Volume control on your iPod, MP3 or CD player to ensure an adequate signal and then
adjust the volume on the radio for comfortable listening.
NOTE
Never use the Aux-In socket in rainy or moist conditions to prevent moist from entering the radio.
Always keep the rubber cover on the back well closed under these conditions.

Charging with USB socket

Your radio has a USB socket which is intended for charging an iPhone, smart phone or similar
devices. Charge time may vary and in some cases may take longer to charge than when using the
manufacturers charging unit supplied with the smart phone.
When using AC power cord and the radio is in power on or standby mode or when using batteries only
and the radio is in power on mode, the radio can charge the iPhone, smart phone or similar devices.
NOTE
1.
The USB jack can only provide power for the USB memory stick only with 1A 5V maximum
and most of iPhone models. However, it does not support external Hard disk drive, all types of
mobile phones and electronic device.
2.
The maximum volume of the output power speaker will decrease when your USB is charging.
IMPORTANT
1.
Do not connect this USB socket with your PC USB port, as it highly possible may cause
breakdown of the unit.
2.
Never use the USB socket in rainy or moist conditions to prevent moist from entering the radio.
Always keep the rubber cover on the back well closed under these conditions.
037