Table of Contents
Advertisement
Finding new stations – DAB
From time to time, new DAB radio stations may become available. Or you may have moved to a
different part of the country. In this case you may need to cause your radio to scan for new stations.
1.
Press and release the Menu button until the Advanced DAB menu shows on the display.
2.
Rotate the Tuning control until 'Full Scan' is shown on the display.
3.
Press the Tuning control to initiate the scan. The display will show 'Scanning' and your radio will
perform a scan of the DAB Band III frequencies. As new stations are found the station counter will
increase and stations will be added to the list. The bar graph indicates the progress of the scan.
4.
Alternatively press Auto tune button to scan for new stations.
Manual tuning – DAB
Manual tuning allows you to tune your radio to a particular DAB frequency in Band III. Any new stations
found will be added to the station list. This function can also be used to assist the positioning of the
antenna or the radio to optimize reception for a specific channel or frequency.
1.
Press and release the Menu button until the Advanced DAB menu shows on the display.
2.
Rotate the Tuning control until the display shows 'Manual Tune'.
3.
Press and release the Tuning control to enter the manual tuning mode.
4.
Rotate the Tuning control to select the desired DAB channel.
5.
Press and release the Tuning control. The open block in the signal strength graph shows the
minimum signal strength needed for good DAB reception. The signal blocks will go up and down
showing the changing signal strength as you adjust the antenna or the radio position. Any new
radio stations found on the tuned DAB multiplex will be added to the list stored in the radio.
6.
Press and release the Tuning control to return to normal tuning mode.
015
Advertisement
Table of Contents
