Sleep Function; Headphone Socket - Sangean PR-D17 Manual

Setting radio alarm time
Ensure that the time is set correctly before setting the alarms. The alarm can be set when the radio is on or off.
1.
Press the Alarm button,
2.
Rotate the Tuning knob to select "ALARM OFF" or "ALARM ON". If "ALARM OFF" is selected any current setting for
that alarm will be cancelled. With "ALARM ON" selected, press the Tuning knob to enter the alarm time setting. The
hour digits will flash on the display.
3.
Rotate the Tuning knob to select the hour then press the Tuning knob to confirm hour setting, and the minute digits
will flash.
4.
Rotate the Tuning knob to select the minute then press the Tuning knob to finish setting.
5.
The radio will play the last played radio station at the chosen alarm time. Use the volume knob to adjust the volume
for the alarm.
6.
While the alarm is sounding, press the Power button or Alarm button to stop it.
NOTE
If it is under AUX band, the alarm will sound by buzzer. When the buzzer alarm activates, the alarm will start softly
and gradually increase in level (Humane Wake System). It will sound for 1 minute and silence for 1 minute in
repetition for 60 minutes unless cancelled.

Sleep function

The sleep timer will automatically switch off the radio after a preset time has elapsed.
1.
Press the Sleep button,
2.
Rotate the Tuning knob to select the required sleep time (60-45-30-15-120-90 minutes).
GB
3.
Press the Tuning knob to confirm the setting.
4.
To cancel the sleep time before the preset time has elapsed and to turn off the radio, press the Power button to turn
E
the unit off manually.
FM Stereo / Mono selection
The FM Stereo / Mono mode switch is on left the side of the radio.
When the FM signal is weak, some hiss may be audible. To reduce the hiss, slide the Stereo / Mono switch to Mono
mode.

Headphone socket

A standard 3.5mm headphone socket located on the left side of your radio is provided for use with headphones.
Inserting earbuds or headphones will automatically mute the internal speaker.
Please be aware that the sensitivity of headphones can vary widely. We therefore recommend setting the volume to a
low level before connecting headphones to the radio.
IMPORTANT
● Excessive sound pressure from Earbuds or Headphones can cause hearing loss.
● To prevent possible hearing damage, do not listen at high volume levels for long periods of time.
07
will flash on the display.
will flash on the display.
will stop flashing on the display.