Operating Your Radio - Fm Auto-Tune - Sangean U4 DBT+ Manual

Operating your radio – FM auto-tune
1.
Straighten up the antenna.
2.
Press the Power button to switch on your radio.
3.
Press and release the Source button until the FM band is selected.
4.
To scan up in frequency, first rotate the Tuning control knob in a clockwise direction and then press
the Auto tune button. Your radio will scan in an upwards direction (low frequency to high frequency)
and stop automatically when it finds a station of sufficient strength.
To scan down in frequency, first rotate the Tuning control knob in an anti-clockwise direction
and then press the Auto tune button. Your radio will scan in a downwards direction and stop
automatically when it finds a station of sufficient strength.
5.
After a few seconds the display will update. The display will show the frequency of the signal
found. If the signal is strong enough and there is RDS data present then the radio may display the
station name.
6.
To find other stations press the Auto tune button as before. When the end of the waveband is
reached, your radio will recommence tuning from the opposite end of the waveband.
7.
Adjust the Volume to the required setting.
8.
To switch off your radio, press the Power button.
NOTE
If you find that FM reception is poor, try repositioning the antenna.
019