Advertisement
14. You will next pin the camera cable wires
into the provided connecter. Inset the pins
into the connecter until they make a "snap"
sound. Use the left side camera harness to
match up where the pin locations are. (See
Diagram chart 1a. at end of instructions for
all camera pin connections.)
15. Attach the camera cable to the harness and
route though the door to the rubber boot.
Secure the harness to the factory wire
harness with zip ties.
16. Route the harness out though the rubber
boot into the vehicle. ( The vehicle might
have a Molex or plastic plug in the door of
body, if so drill a hole in the plug if there is
any room to, if not drill a hole lower in the
door jus under the rubber boot and the
same if the plug is in the body. Grommet
and seal any holes that might be drilled.)
17. Route the harness to the 360º module.
18. Reinstall the mirror glass into the mirror and
reinstall the door panel.
19. Repeat the process on the passenger side
door and then continue to the next section.
Section 3:
Rear camera installation
1. The rear camera on this vehicle will be in
the tailgate handle. The camera is already
mounted to the handle.
2. Remove the trim panel on the backside of
the tailgate, by removing the Torx screws
holding it in place.
3600 Instructions 9-1-15
!
INSTALLATION!INSTRUCTIONS!
3. Unclip the latch rods the go to the handle.
4. Loosen the (2) 10 mm nuts holding the
5. Remove the handle and install the new
6. Connect the camera cable to the rear
7. Route the harness through the tailgate and
8. Route the harness on the underside of the
Page 4 of 19
( If equipped with a rear camera, unplug it
from the harness.)
handle in place.
handle with the 360º camera installed.
camera harness and heat shrink or tape the
connection.
into the lower bed frame. ( If holes do not
exist in the tailgate or bed frame you must
drill new holes in to each to run harness.
Make sure to use grommets and seal up
holes to prevent rust or cutting of harness.)
vehicle. Use zip ties to hold harness in place
and be careful to avoid any moving parts or
exhaust.
Advertisement
