Advertisement
Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Step 1: Select and Install Camera Bracket
Determine which of the two supplied camera
mounting methods you prefer.
License Plate Bracket
Alternate Camera Mount Bracket
Place camera in desired position to confirm fitment
(Note: Some states prohibit items blocking the license
plate; check local authorities to confirm legal status for
your application).
If using License Plate Bracket, remove license
plate. Reattach license plate securing bracket behind.
If using Alternate Camera Mount Bracket, remove
camera from License Plate Bracket using supplied Allen
wrench. Attach camera to the Alternate Camera Mount
bracket and apply supplied self-adhesive foam to mount.
Use the Template included in the Installation
Instruction Overview to position the Alternate Camera
Mount on vehicle
Clean vehicle surface to which mount is to be
attached and affix with self-adhesive foam.
RECOMMENDED: Permanent attachment using screws.
Step 2: Measure, mark, and drill ¼" hole for
camera harness. NOTE: If your vehicle has a liftgate
panel/trunk trim cover, it must be removed.
9002-7601 Instructions for printing.doc
Installation Instructions (Kit # 9002-7601)
Step 3: Determine location of vehicle power and
ground. Using a vehicle specific service guide and/or
specific wiring diagram and a multi-meter or computer-
safe test light, locate which side of the vehicle contains
Ignition and Ground wires (Chart A).
Wire
Color
Polarity
Function
Red
12v +
controlled
Black
(-)
CAUTION: Once correct wires have been identified,
turn Ignition key OFF and DO NOT TURN key back ON
until the install has been completed (Step 13).
Step 4: Splice the red
and black Power Harness
leads into the
corresponding vehicle
wires (Recommended:
Soldering or T-taps as
optional connection
method). Also
recommended is an eyelet
for the ground connection.
Step 5: Insert the connector end of the Camera
Harness through the hole you drilled.
(RECOMMENDED: Protect Camera Harness from sharp
metal edges by applying a small amount of silicone caulk
or a rubber grommet to the area that comes into contact
with the metal).
Page 2 of 5
Chart A
Description
This lead will display
Ignition
12 volt + when the
key is in the RUN
power
position
Ground
Chassis ground
Location
Commonly
found on
main
Ignition
harness.
A ground
bolt is
commonly
found in the
front kick
panel area
with other
wires
attached.
GS
Advertisement
