BrandMotion FLEETWORKS FLTW-7610 Installation Instructions

Ram Promaster Camera
Please read thoroughly before starting installation and check that kit contents are
complete. This kit uses existing light from vehicle PN#68169776AB
Items Included in the Kit:
Camera
Gasket
Chassis Harness
2 Bolts
2 Washers
2 Nuts
4 Screws
Camera adjustment tool
These Instructions
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
Step 1: Remove high center red light from
vehicle. Unplug connector of lamp.
Step 2: Insert connector end of the Camera
Harness through the hole.
(Kit # FLTW-7610)
NOTE: We strive to provide accurate and up-to-date installation
INSTALLATION I NSTRUCTIONS
with Optional Park Lines
Tools & Supplies Needed:
Phillips Screw Driver
Wire Ties
Electrical Tape or Heat Shrink Tubing
Plastic Trim Removal Tool
Soldering Iron & Solder
Vehicle service manual (If needed)
instructions.
Step 3: Mount camera base to vehicle using
the provide nuts and bolts.
Step 4: Route rear lamp connector though
camera base and surround.
Step 5: Use screws to mount camera
surround to camera base.
Step 6: Connect and mount high center red
light to camera surround using provided
screws
(Recommended)