Doosan D35S-5 Service Manual page 216

Description of Power Supplying Method
Power supply with the DLC cable
The vehicle with diagnosis connector terminal of the 20-Pin connector or which is satisfying the OBD-II
communication regulation can get electric power from the DLC cable without any additional power line.
NOTE : The DLC connector, in general, is located on the lower part of the driver's front panel. This location
may be different somewhat. Please check the correct location before connecting.
From the cigar lighter terminal
Using the Cable-Cigar, the electric power can be supplied.
NOTE : When using the Cable - Cigar, the power will be off during cranking of the engine. If your G-scan does
not have rechargeable battery and you diagnose vehicle relating to the cranking of engine, use other power
supplying method.
From the vehicle battery
When power is supplied from the vehicle battery, the electric power can be supplied without interruption.
Caution at connecting the vehicle battery
• Do not get the battery power line to the driving part in the engine room.
• Do not reverse the positive(+) and negative(-) terminals.
From the AC/DC adapter
Using the AC/DC adapter, the electric power can be supplied to G-scan.
When updating G-scan, use the AC/DC adapter for supplying stable power to G-scan.
Use only the AC/DC adapter (GHDM-260001) supplied by G.I.T for G-scan. G.I.T has not responsibility
for the damage by using other AC/DC adapter.
• When communicating with vehicle (for all vehicle diagnosis function with DLC cable), G-scan should
be connected with vehicles battery directly or indirectly (DLC).
• For updating G-scan, connect the AC/DC adapter for supplying the stable power.
D439E Service Manual
WARNING
CAUTION
214 5. Service Tool