Emerson Rosemount CX1100 Reference Manual page 39

Table 7-2:
Parameter label
O LRV
2
O URV
2
AO Range
Alarm Level
Relay 1
Relay 2
AO Track
Cal Gas 1
Cal Gas 2
Gas Time
Purge Time
Imp Check Hold
Remote CJC
Raw Counts | Cell Voltage
Raw Counts | Cell Imp
Raw Counts | T/C Voltage
Raw Counts | Heater Voltage
Cal State
Time Remain
Slope
Reference Manual
Probe Parameters
(continued)
Description
Primary variable, O %, lower range value. (0.0%
2
only)
Primary variable, O % upper range value (1.0% -
2
50.0%)
Analog ouput polarity
O alarm level
2
Alarm Relay 1 mode
Alarm Relay 2 mode
Analog output track O sensor measurement
2
during a calibration
Test Gas 1 value. This is the actual value of the
gas being applied during the Test Gas 1 phase
of a calibration. (0.05 - 50.0%)
Test Gas 2 value. this is the actual value of the
gas being applied during the Test Gas 2 phase
of calibration. (0.05 - 50.0%)
Test gas application time. This is the length of
time test gases are applied to the O
ing low or high test gas phase of a calibration.
(60 - 1200 sec)
Test gas purge time. This is the length of time
before the output will be returned to the proc-
ess reading after a calibration. (60 - 1200 sec)
Time to hold analog output during impedance
check. (0 - 60 sec) (Factory mode only)
Use local or remote CJC measurement for cor-
rection. (No/Yes) (Factory mode only)
O sensor voltage raw counts. (Factory mode
2
only)
Cell impedance/sensor resistance raw counts.
(Factory mode only)
O T/C raw counts. (Factory mode only)
2
Heater voltage raw counts. (Factory mode only)
This represents the state of the calibration cycle
it is in.
Time remaining in the present calibration cycle
state.
Current calibration slope. This is the slope value
that was calculated as a result of the last suc-
cessful calibration. (34.5 to 57.5 mV/Dec)
Parameters
probe dur-
2
33