Transaxle Assembly; Remove And Install - Taylor-Dunn RE-380-36 Service And Replacement Parts Manual

RE-380-36 & RE-380-48

TRANSAXLE ASSEMBLY

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Note: The transmission assembly will be removed with the springs attached. Refer to Suspension section for
information regarding removing the springs.

Remove and Install

1: Remove the motor wires.
2: Disconnect the left and right mechanical parking brake linkage from the brake arms and the cable mounting
brackets.
3: Disconnect the hydraulic brake hoses from the rear brake calipers.
4: Remove the nuts from the rear spring hangers and the front frame mount. Do not remove the bolts at this
time.
5: Lift the rear of the vehicle just enough to allow the removal of the spring mounting bolts and remove the
bolts.
6: Raise the rear of the vehicle high enough to roll the transmission out from under the vehicle and support with
jack stands.
7: Install in reverse order.
8: Bleed the brake system. Refer to Bleed the Brakes in the Brake Service section for information regarding
bleeding the brake system.
9: Check brake adjustment and adjust as needed. Refer to Adjust the Brakes in the Brake Service section for
information regarding adjusting the brakes.
10: Reconnect the main positive and negative at the batteries, remove the blocks from the wheels, and test
drive.
MR-380-05
Transaxle - GT
Page 41